Welcome to

 

 

Ingredients

6*8mm red pearl beads,

8*6mm red pearl beads,

2 Silver plated earring findings,

1 Silver plated lobster clasp,

16inch silver plated chain.

11 eye pin's

2 Headpins

 

First I put all of the 6mm red pearl beads onto eye pins, trimmed the remaining wire one the other end of the pin to roughly around 1cm and using a pair of ring nosed pliers made that end into a loop. I them again repeated this on 4 of the 8mm pearl beads. The remaining two 8mm I put on the two head pins again cutting the remaining wire to 1cm and created a loop.

Working with the pattern of a 6mm pearl followed by a 8mm pearl and then again a 6mm pearl, I connected these by adding 1 and a half inches of chain in between each of the beads until I reached the last of the pearls allocated to the necklace. I the split the remaining chain in two and placed at either end of the beads and placed a lobster clasp on the end.

 

To make the matching earrings I linked the two 8mm pearls that were on head pins to the remaining 2 6mm pearls and then linked other end of the 6mm pearls to the earrings.

This then created this necklace and earring set.